|
Installing the "Bullet" |
|
1. Unthread Bolt form Bullet with 5/16”
Allen Wrench |
|
 2.
Remove existing bolt from jack - maybe
installed on either side of jack or on
the crossover shaft
|
|
3. Replace hex head cap bolt into bullet
|
|
 4.
Apply thread lock compound to threads of
bolt (mandatory)
|
|
 5.
Insert bolt into existing hole in jack
|
|
 6.
Thread into bottom half of bullet
|
|
 |
|
To Lock: |
 7.
Slide locking Barrels with tabs over
each end of bullet and align holes |
|
 8.
Insert Padlock into holes in tabs |
|
9. Enjoy the Peace of Mind You Will have
knowing your trailer is safe and secure! |
|
The bullet installs in steps 1-6 and
remains on the trailer at all times.
When lock is applied the jack will not
turn,
keeping anyone from hooking to your
trailer. |
Benefits
 |
Installs in just minutes
|
|
May be installed on either
side of jack |
|
If installed on the
crossover shaft it's almost
invisible
|
|
Once the bullet is installed
it stays there. Just toss
the locking barrels in your
vehicle/cab and take them
out when you need to secure
your trailer.
|
|
Made in the USA
|
|
|
